Tcpip - GE LOGIQ P9 Service Manual

GERAFT
D 5604324, R
IRECTION EVISION
3-13-4

TCPIP

This configuration category enables users with administrative rights to set the TCPIP for the system and
connected remote archive.
1) Type the name of the Ultrasound system in the Computer Name field.
2) Identify the ultrasound system to the rest of the network by one of the following:
-
-
NOTE: Do not set up the system with DHCP. The IP address MUST BE static for the diagnostic and DICOM to
function correctly.
3) Select Save settings.
4) Re-boot the ultrasound system.
NOTE: TCPIP settings do not get restored when restoring backups. This is per system design.
The LOGIQ P9/P7 IP address MUST BE unique.
Table 3-22
Preset Parameter
Computer Name
Table 3-23
Preset Parameter
Enable DHCP
3-60
11 DRAFT (J
DO NOT enable DHCP in the Wired Network Configuration Section..
In the Wired Connection Section, Type the IP-Address (acquire unique static IP address from
hospital network administrator), Subnet Mask, and Default Gateway (if applicable).
Figure 3-36 Connectivity TCPIP Preset Menu
Computer Name
Type the unique name for the Ultrasound system (no spaces in name).
Wired Network Configuration
Select this box to enable dynamic IP Address selection.
NOTE: The system shall disable IP-Address, Subnet Mask, and Default Gateway when the user
chooses to use DHCP.
Section 3-13 - Configuring Connectivity
24, 2019)
ANUARY
Description
Description
LOGIQ P9/P7
S M
ERVICE ANUAL