GE LOGIQ P9 Service Manual page 429

Hide thumbs Also See for LOGIQ P9:

Table of Contents

Removal Procedure - Nest Box

Before working with Nest box, be sure to remove probes.

1) Remove front cover. (refer to section 8-6)

2) Disconnect 1 fan connector of bottom fan.

3) Unlock cable clamp, then pull out connector and cable of bottom fan. Refer to following figures.

4) Remove 2 screws on front side.

5) Remove the rear cover. (refer to section 8-9)

6) Remove Power cord fix bracket and power cord. (refer to section 8-17)

7) Remove cable cover bracket and disconnect cables. (refer to section 8-17)

Figure 8-109 Fan Connector

Figure 8-110 Front side screw points

Chapter 8 - Replacement Procedures

Show Quick Links

Table of Contents