Table of Contents
Advertisement
The confirmation dialog box appears.
4
Press the USBTMC soft key again to confirm the mode change and reboot the instrument.
NOTE
After using the USBTMC mode, you may want to set this setting back to App SW if you
use JDViewer mainly for remote controlling your JD700B series.
Setting SCPI mode
You can use SCPI commands to control your JD700B series remotely.
Procedure
1
Press the SYSTEM hot key.
2
Select System Configuration > Remote Interface > LAN.
3
Press the SCPI soft key.
NOTE
After using the SCPI mode, you may want to set this setting back to App SW if you use
JDViewer or JDRemote mainly.
Configuring LMF setting
The Local Maintenance Facility (LMF) setting is used in order to perform TX Calibration and TX Audit
on Motorola's CDMA/EV-DO BTS in the RF Power Meter mode. See "Appendix F – Motorola
CDMA/EV-DO LMF" on page 535 for more information.
Enabling Bluetooth connection
You can also use the Bluetooth mode to enable communicate between your instrument and your
computer with application software such as JDRemote and JDViewer or to transfer files to a Bluetooth
storage device. See "Appendix G – Bluetooth connection" on page 537 for more information.
JD700B Series User's Guide
Chapter 2 Getting Started
47
Advertisement
Table of Contents
