Table of Contents
Advertisement
Chapter 15 Using RFoCPRI Interference Analyzer
Procedure
1
Press the BW/AVG hard key.
2
Press the Average soft key.
3
Enter a value between one and 100 as needed by using the numeric keys.
4
Press the Enter soft key.
Setting sweep mode
The default setting is Continue to sweep continuously for most on-going measurements. If you want to
hold the measurement or get a single sweep, you can change the sweep mode. This setting is used in
the Spectrum, Spectrogram, and RSSI modes.
Procedure
To select the single sweep mode:
1
Press the SWEEP hot key.
2
Toggle the Sweep Mode soft key and select Single. You can also use the HOLD hot key.
The letter
3
Optional. Press the Sweep Once soft key to get a new measurement.
To return to the continuous sweep mode:
1
Toggle the Sweep Mode soft key and select Continue. You can also use the HOLD hot key.
The letter
Setting trace
You can display up to six traces on the measurement chart simultaneously.
Procedure
1
Press the TRACE/DISPLAY hard key.
2
Press the Select Trace soft key, and then select the trace number: T1, T2, T3, T4, T5, or T6.
The legend shape of the selected trace changes from square to round to indicate that the trace is
the active one now.
3
Toggle the Trace View soft key and select On.
4
Do one of the following:
To
Clear current data and display with new
measurements
Display the input signal's maximum response only
(unlimited or for a certain amount of time)
Display the input signal's minimum response only
(unlimited or for a certain amount of time)
Capture the selected trace and compare traces
Load a saved trace
Hide the selected trace
Remove all the traces and initialize the trace
settings
484
HOLD
in red appears and the sweeping is paused.
HOLD
in red disappears and the sweeping resumes.
JD700B Series User's Guide
Select
Trace Legend
Clear Write
W
Max Hold
M
Min Hold
m
Capture
C
More (1/2) > Load
L
Trace View > Off
F
More (1/2) > Trace
Clear All
Advertisement
Table of Contents
