Table of Contents
Advertisement
Appendix
Figure 286 Using external power sensor
Performing a LMF test
Procedure
1
Press the SYSTEM hot key.
2
To set the IP address, complete the following steps:
a
Select System Configuration > Ethernet Config.
b
Toggle the Mode soft key and select Static.
c
Press the Field > IP Address soft key.
d
Set the IP address as "192.167.10.1".
3
Select Remote Interface > LAN > LMF.
4
To set up the LMF settings, complete the following steps:
a
Press the LMF Settings soft key.
b
Select the power measurement and BTS option from the following choices:
–
–
–
–
5
To select the measurement mode, complete the following steps:
a
Press the MODE hard key.
b
Press the Power Meter soft key.
c
Select Internal RF Power Meter or External RF Power Meter depending on your LMF
settings. The measurement result is displayed on the screen.
536
External PM 800 MHz Band for external measurement on cellular basestation
External PM 1900 MHz Band for external meausrement on PCS basestation
Internal PM 800 MHz Band for internal measurement on celluar basestation
Internal PM 1900 MHz Band for internal measurement on PCS basestation
JD700B Series User's Guide
Advertisement
Table of Contents
