Table of Contents
Advertisement
Measurement example
Figure 183 MAC CDP Table measurement with EV-DO signal analyzer
Setting display
If the MAC CDP table spans over to the next page(s), you can change pages up and down to view
your measurement results.
Procedure
1
Press the TRACE/DISPLAY hard key.
2
Select Page Up or Page Down as needed to scroll the screen up and down.
Setting limit for modulation tests
Procedure
1
Press the LIMIT hot key.
2
Press the Modulation Test Limits soft key.
3
Select the test item(s) and set the limit(s) depending on your selected measurement mode:
To set the limit for
Frequency error
Time offset
Carrier feed through
Highest level among inactive channels
Waveform quality (Rho) for pilot
Waveform quality (Rho) for MAC
Waveform quality (Rho) for data
Select
Frequency Error
Time Offset
Carrier Feed Through
Max Inactive
Pilot Rho
MAC Rho
Data Rho
JD700B Series User's Guide
Chapter 11 Using EV-DO Signal Analyzer
Set
High Limit
Low Limit
High Limit
Low Limit
High Limit
High Limit
Low Limit
Low Limit
Low Limit
359
Advertisement
Table of Contents
