Table of Contents
Advertisement
Chapter 9 Using LTE - TDD Signal Analyzer
Procedure
1
Press the MEASURE SETUP hot key.
2
To set the nominal channel bandwidth to be measured, complete the following steps:
a
Press the Bandwidth soft key.
b
Select the bandwidth option from the choices: 1.4 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz,
and 20 MHz.
3
To set the frequency, do one of the following:
–
To set the center frequency, complete the following steps:
a
b
c
d
e
f
g
–
To set the channel number, complete the following steps:
a
NOTE
Selecting Channel sets the standard channel to Band Global automatically so that you
can set the Channel Number without choosing a standard channel band from the list.
b
c
d
e
f
g
Measurement example
Figure 117 Multi-ACLR measurement with LTE - TDD signal analyzer
246
Toggle the Unit soft key and select Freq.
Press the Lowest Frequency soft key to set the starting center frequency.
Enter a value by using the numeric keys. You can also use the rotary knob.
Select the unit: GHz, MHz, kHz, or Hz.
Press the Highest Frequency soft key to set the stopping center frequency.
Enter a value by using the numeric keys. You can also use the rotary knob.
Select the unit: GHz, MHz, kHz, or Hz.
Toggle the Unit soft key and select Channel.
Press the Lowest Channel soft key to set the starting channel.
Enter a value by using the numeric keys. You can also use the rotary knob.
Press the Enter soft key.
Press the Highest Channel soft key to set the stopping channel.
Enter a value by using the numeric keys. You can also use the rotary knob.
Press the Enter soft key.
JD700B Series User's Guide
Advertisement
Table of Contents
