Table of Contents
Advertisement
Chapter 15 Using RFoCPRI Interference Analyzer
5
Toggle the Sound soft key between On and Off and select On to enable to sound. To turn it off,
select Off.
6
Optional. To adjust the volume for alarm sound, press the Volume soft key, and then turn the
rotary knob clockwise or counter clockwise.
7
Optional. You can save logging data automatically so that you can load the measurement data
and replay in the Spectrum Replayer mode. See "Using save" on page 32 for more information.
Interference ID
The Interference ID automatically classifies interfering signals over a designated spectrum and
displays a list of possible signal types corresponding to the selected signal.
Procedure
1
Press the MEASURE SETUP hot key.
2
Press the Interference ID soft key.
3
To set the threshold, complete the following steps:
a
Press the Threshold soft key.
b
Enter a value by using the numeric keys. You can also use the rotary knob.
c
Press the dBm soft key.
4
Toggle the Interference ID soft key between On and Off and select On to enable the Interference
ID. To turn it off, select Off.
5
Optional. Go to SAVE/LOAD > Save, and then select the save option from the choices available
for your measurement mode. See "Using save" on page 32 for more information.
NOTE
You can use the LIMIT hot key to analyze your measurements with the display line, multi-
segment line, and channel limit. See "Setting limit for interference analyzer" on page 491
for more information.
Measurement example
Figure 259 RFoCPRI spectrum measurement
486
JD700B Series User's Guide
Advertisement
Table of Contents
