JDS Uniphase CellAdvisor JD700B Series User Manual page 149

128, or 256.
d Press the Spread Code soft key to set the spread code.
e Enter a value by using the numeric keys.
f Press the Enter soft key.
5
To set the PICH information of the system to be tested, complete the following steps:
a Press the PICH soft key.
b Toggle the PICH soft key between On and Off to enable or disable the PICH.
c Press the Spread Factor soft key, and then select the spread factor option: 4, 8, 16, 32, 64,
128, or 256.
d Press the Spread Code soft key to set the spread code.
e Enter a value by using the numeric keys.
f Press the Enter soft key.
6
Optional. To set the threshold, complete the following steps:
a Press the Threshold soft key.
b Enter a value by using the numeric keys.
c Press the Enter soft key.
Measurement example
Figure 60 Code domain power measurement with WCDMA/HSPA+ signal analyzer
1) Full screen
JD700B Series User's Guide
Chapter 7 Using WCDMA/HSPA+ Signal Analyzer
149