Table of Contents
Advertisement
Measurement example
Figure 163 Code domain power measurement with CDMA OTA signal analyzer
NOTE
You can use the LIMIT hot key to analyze your measurements with the user-definable
limit and Pass/Fail indication.
Setting display
You can view your measurement results in a different view option.
Procedure
1
Press the TRACE/DISPLAY hard key.
2
Press the Code Order soft key, and then select the code order option from the following choices:
–
Hadamard: To assign the number based on Walsh code order and display the measured
code power according to the assigned number in sequence.
–
Bit Reverse: Code number in binary bit is reversed relative to the Hadamard method.
3
Toggle the Base Code Length soft key and select the base Walsh code number: 64 or 128.
Route map
The JD700B Series provides indoor and outdoor mapping function that allows a user to collect data of
points in an indoor or outdoor environment and track the received signals and coverage of RF
transmitters plotting real time directly on top of a loaded floor plan or a map.
Setting measure setup
Procedure
1
If required, connect a GPS receiver to your JD700B series for outdoor mapping.
Indoor mapping does not necessarily need a GPS antenna.
2
Configure test parameters as described in the "Configuring test parameters" on page 297.
3
To load your map file, complete the following steps:
JD700B Series User's Guide
Chapter 10 Using CDMA Signal Analyzer
327
Advertisement
Table of Contents
