Measurement Example; Performing Carrier Aggregation Measurements; Setting Measure Setup - JDS Uniphase CellAdvisor JD700B Series User Manual

Chapter 8 Using LTE - FDD Signal Analyzer
can continue your measurement. The measurement settings can be saved and recalled as a file. You
can also use JDViewer, PC application software to configure a measure setup, save as a file, and load
the file on to the instrument.
Procedure
1
Press the MEASURE SETUP hot key.
2
Press the CCDF Length soft key to set the length of the CCDF.
3
Enter a value between 1 and 100 by using the numeric keys. You can also use the rotary knob.
4
Press the Enter soft key.

Measurement example

Figure 98 CCDF measurement with LTE - FDD signal analyzer

Performing carrier aggregation measurements

Carrier aggregation enables a maximum of five multiple LTE carriers to be used together in order to
provide high data rate required for LTE-Advanced. Component carriers to be aggregated can be intra-
band contiguous, intra-band non-contiguous, or inter-band. The JD700B series provides carrier
aggregation measurements supporting for all the different modes with carrier aggregation bands
added to the channel standard. This functionality is activated if the license for the option 030 LTE-
Advanced FDD is installed.

Setting measure setup

After configuring test parameters as described in the "Configuring test parameters" on page 173, you
can continue your measurement. The measurement settings can be saved and recalled as a file. You
can also use JDViewer, PC application software to configure a measure setup, save as a file, and load
the file on to the instrument.
214
JD700B Series User's Guide