Setting Limit - JDS Uniphase JD7105B Manual

JD7105B Base Station Analyzer
 RX FILTER: Sets the internal RX filter bandwidth among 100K, 200K, 400K, and 624K. Default
setting is 400K.

Setting Limit

LIMIT
This hot key is used to set the threshold value for the limit line on the display screen. It turns on or off
the limit or band limit settings of the measurement for pass/fail indication. The user input window must
be inactive first to get the Limit hot key function other than the number input.
Step
1. Select the limit mode
LIMIT
[RF Test Limits]
[Channel Power]
2. Set the limit
[Test Limits]
<On> or <Off>
[High Limit]
Enter a value
[dBm] or ENTER
[Low Limit]
Enter a value
[dBm] or ENTER
3. Enable beep
LIMIT
[Beep]
<On> or <Off>

TEST LIMITS: Enables or disables Pass/Fail results on the display screen. Toggle the Test
Limits soft key to select it to On or Off.
 HIGH LIMIT: Sets the upper limit of the Pass/Fail criteria. Use the numeric keys to enter a
threshold or limit value and press the dBm unit soft key or the ENTER hard key to complete the
input.
 LOW LIMIT: Sets the lower limit of the Pass/Fail criteria. Use the numeric keys to enter a
GSM/GPRS/EDGE SIGNAL ANALYZER
Description
Press the LIMIT hot key. It is the number 7 key in the
numeric keypad.
Press the RF Test Limits soft key to enable or disable
test limits on RF Analysis measurements.
Press the Channel Power soft key.
Press the Test Limits soft key to toggle between On and
Off and select one.
Press the High Limit soft key to set the upper limit of the
Pass/Fail criteria. Use the numeric keys to input value.
Press the unit soft key or the ENTER hard key.
Press the Low Limit soft key to set the lower limit of the
Pass/Fail criteria. Use the numeric keys to input value.
Press the unit soft key or the ENTER hard key.
Press the LIMIT hot key. It is the number 7 key in the
numeric keypad.
Press the Beep soft key to toggle between On and Off
and select one. This will make audible alarm if the
measurement beyond the limit.
22