Guard Code Options - Bosch DS7240-UK Reference Manual

34.8

Guard Code Options

• Address: 0705
• Default: 0 (No Guard Code Options)
• Selections:
• 0 = No Guard Code Options
• 1 = User 28 is a Guard Code
34.8.1 Parameter Description
User 28 can be programmed as a Guard Code. The Guard Code only works in the areas that User 28 is assigned. The
authority level assigned to the Guard Code (User 28) dictates which keypad functions the guard can use.
For example, Authority Level Configuration Option 1 configures All On arming. If this is set to 0 (zero), the guard can arm at
any time. If the guard's authority level does not allow All On arming, then the guard can never arm All On. If the guard's
authority level allows All On arming, the guard can arm the area All On only if the Guard Code was used to disarm the area.
Authority Level Configuration Options 2 and 3 configure Perimeter Only Arming and Partial On arming. If these are set to 0
(zero), then the guard can arm in these modes at any time. If the guard's authority level does not allow these modes, then the
guard can never arm using these modes. If the guard's authority level allows these modes, then the guard can arm the area
using these modes only if the Guard Code was used to disarm the area.
Authority Level Configuration Option 4 configures system disarming. If this is set to 0 (zero), the guard can never disarm the
system. If the guard's authority level does not allow disarming, the guard can never disarm the area. If the guard's authority
level does allow disarming, then the Guard Code can only disarm the system if the system had a non-silenced alarm.
Authority Level Configuration Options 5-15 operate the same for the Guard Code as they do for any other user code. Enabling
or disabling these options controls which functions the Guard Code can perform.
DS7240-UK Reference Guide
Copyright © 2003 Bosch Security Systems
P/N: 4998122677Cr1 Page 85
PART III: PANEL PROGRAMMING