Table of Contents
Advertisement
47.0 Tamper Response Configuration
47.1
Tamper Alarm/Trouble Options
• Address: 3406
• Default: See table below
• Selections: 0-15
Tamper Alarm/Trouble Options
No Tamper Alarms, no Trouble or Restoral Reports
Tamper Alarm when Armed (Set)
Tamper Alarm when Disarmed (Unset)
Send Tamper Trouble Reports
Send Tamper Trouble Restoral Reports
47.1.1
Parameter Description
This is a global parameter. Use it to configure the panel's response when tamper alarms occur, and whether tamper trouble
and tamper trouble restoral reports are sent.
47.1.2
Parameter Options
• Tamper Alarm when Armed (Set): If this option is selected, a tamper condition that occurs when the panel is armed creates
a tamper alarm response. If this option is not selected, a tamper condition that occurs when the panel is armed creates a
tamper trouble condition.
When the panel is armed (set) Perimeter Only or Part On, only some of the controlled zones can create an alarm. If this
option is selected and the zone that is tampered is a Perimeter Only or Part On zone, a tamper alarm is created. If the zone
is not a Perimeter Only or Part On zone, the tamper response depdends on the setting made for the next option (Tamper
Alarm when Disarmed (Unset)). The non-zone tampers are always included in the Perimeter Only or Part On zones and
would create a tamper alarm if tampered.
• Tamper Alarm when Disarmed (Unset): If this option is selected, a tamper condition that occurs when the panel is
disarmed creates a tamper alarm response. If this option is not selected, a tamper condition that occurs when the panel is
disarmed creates a tamper trouble condition.
If the panel is armed (set) Perimeter Only or Part On, the zones that are excluded from the controlled zones respond to the
tamper condition as defined by the setting of this option.
• Send Tamper Trouble Reports: If this option is selected, a tamper trouble report is sent to the central station when a
tamper trouble (not alarm) occurs. If this option is not selected, no report is sent.
• Send Tamper Trouble Restoral Reports: If this option is selected, a tamper trouble restoral report is sent to the central
station when a tamper trouble restores. If this option is not selected, no report is sent.
DS7240-UK Reference Guide
0
• •
Copyright © 2003 Bosch Security Systems
Enter This Data Digit to Select Options
1
2
3
4
5
6
7
8
• •
• •
• •
• •
• • • •
• • • •
• • • • • • • •
• • • • • • • • • • • • • • • •
PART III: PANEL PROGRAMMING
9 10 11 12 13 14 15
• •
• •
• •
• •
• • • •
• • • •
• • • • • • • •
P/N: 4998122677Cr1 Page 131
Advertisement
Table of Contents
