Table of Contents
Advertisement
41.8
DX2010 Configuration Options
• Address:
• 1257 = DX2010 Address 101
• 1258 = DX2010 Address 102
• 1259 = DX2010 Address 103
• 1260 = DX2010 Address 104
• 1261 = DX2010 Address 105
• Default: See table below
• Selections: 0-11
DX2010 Configuration Options
300 ms Debounce Time
150 ms Debounce Time
75 ms Debounce Time
30 ms Debounce Time
Tamper-wired EOL Resistors
Single 2.2 k EOL Resistor
Single 2.2 k EOL Resistor, 30% Zone
Reserved
41.8.1
Parameter Description
The DX2010 Input Expander sensor loops can be configured for single EOL zones, zone doubling zones, or tamper-wired
zones. The panel distinguishes between single zone inputs and zone doubled inputs by the address assigned to the DX2010.
For tamper-wired zones, the DX2010 modules are assigned to Device Addresses 101-105 and use Wired Zone Expander
device type selection (see Section 35.1 Location ##, Device on page 88). These modules use Programming Addresses 1257-
1261 to set the configuration options using the table above. Addresses 1262 to 1264 are reserved.
DS7240-UK Reference Guide
0
• •
• •
Copyright © 2003 Bosch Security Systems
Enter This Data Digit to Select Options
1
2
3
4
5
6
7
8
• •
• •
• •
• •
• •
• •
• •
• •
• • • • • •
• • • • • • • •
• • • • • • • •
PART III: PANEL PROGRAMMING
9 10 11 12 13 14 15
• •
• •
• •
P/N: 4998122677Cr1 Page 123
Advertisement
Table of Contents
