Table of Contents
Advertisement
28.0 Global Open/Close Options
28.1
Arming Options 1
• Address: 0258
• Default: See table below
• Selections: 0-7
Arming Options 1
No Options Enabled
Perimeter Only if No Entry/Exit
Answering Machine Bypass only when All/Perimeter Only On
Remote Arming with Telephone, Area 1
Reserved
28.1.1
Parameter Options
• Perimeter Only if No Entry/Exit: If this feature is selected and the system is turned All On and no Entry or Exit zones are
faulted during Exit Delay, the system automatically shifts to Perimeter Only. Perimeter Only (not All On) appears in the log
and reports. This feature can only be used if the panel is armed with delay. This feature does not apply when arming with
keyswitches or RF keyfobs.
• Answering Machine Bypass Only When All On/Perimeter Only On: The Answering Machine Bypass function is activated
at the RPS Answer Ring Count, Answering Machine Bypass parameter (see page 36). If activated there, this option can be
used to restrict its function so that it only operates when the system is All On or Perimeter Only On. The system will not
answer if disarmed.
• Remote Arming with Telephone, Area 1: Controls the built-in telephone arming feature for Area 1. When enabled, the
panel answers the phone on the ring count for remote programming.
When the panel answers the phone:
• If the panel is All On or Perimeter Only On, it sounds three beeps and starts the handshake tone for remote
programming.
• If the panel is Off, it sounds one short beep, waits approximately three seconds and then starts the handshake tone for
remote programming (one long beep). Press and hold the [5] key* for two seconds immediately after the first short
arming beep and before the handshake tone begins.
• The panel will arm if it detects a [5] key press from the telephone (All On with Delay, faulted zones are force-armed like
keyswitch arming). The panel sounds three beeps (new armed state) and then hangs up.
* If arming from a cell phone, quickly press the [5] key three times. If pressing and holding the [5] key for two seconds from a
house (landline) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing the [5] key three times.
Remotely disarming the panel cannot be done with a telephone.
DS7240-UK Reference Guide
Copyright © 2003 Bosch Security Systems
Enter This Data Digit to Select Options
0
1
2
3
4
5
6
7
• •
• •
• •
• •
• •
• • • •
• • • •
• • • • • • • •
8
9 10 11 12 13 14 15
P/N: 4998122677Cr1 Page 55
PART III: PANEL PROGRAMMING
Advertisement
Table of Contents
