Table of Contents
Advertisement
2.1.6.4 Pre-Fixing Feed Unit 1 (9 million prints)
imagePRESS C6010 / imagePRES S C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Pre-fixing Feed Belt Cleaning Brush (FL3-2902)
- Fixing feed belt (FC6-8098)
- Pre-fixing feed suction fan (front / rear) (FL2-6885)
2. Before the replacement
1) Pull out the Feed Assembly toward the front. Refer to "Chapter 8 Before
Removing the Pre-fixing Feed Unit 1 and 2" in the Service Manual.
2) Remove the Pre-fixing Feed Belt Cleaning Brush [1].
F-2-192
2-2. Removing the fixing feed belt, pre-fixing feed suction fan (front / rear)
1) Remove the Secondary Transfer Outer Unit. Refer to "Chapter 7 Remov-
ing the Secondary Transfer Outer Unit" in the Service Manual.
2) Remove the Pre-fixing Feed Unit 1 . Refer to "Chapter 8 Removing the
Pre-fixing Feed Unit 1" in the Service Manual.
3) Remove the screw [1].
F-2-193
4) Detach the motor [1].
- 2 screws [2]
0026-4810
5) Detach the pressure support plate [1].
- 4 screws [2]
[2]
6) Detach the pressure support plate [1].
- 2 screws [2]
7) Remove the 4 bushings (w/leaf spring) [1].
- 1 screw [2] each
[1]
Chapter 2
[2]
[1]
F-2-194
[1]
[2]
F-2-195
F-2-196
[1]
[2]
F-2-197
2-45
Advertisement
Table of Contents
