Table of Contents
Advertisement
Chapter 2
[2]
F-2-175
23) Detach the pre-registration feed roller 1 [1] and the pre-registration feed
roller 2 [2].
- Front side
- 1 screw [3] each
- 1 bushing (w/leaf spring) [4] each
- 1 E-ring [5] each
- 1 bearing [6] each
- Rear side
- 1 belt [7] each
- 1 E-ring [8] each
- 1 pulley [9] each
- 1 dowel pin [10] each
- 1 bearing [11] each
[11]
[10]
[9]
[8]
[7]
[7]
F-2-176
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
When detaching the feed roller 1
21) Detach the shaft support (rear) [1].
- 2 screws [2]
- 1 shaft [3]
- 1 claw [4]
2-42
[1]
[2]
[6]
[5]
[4]
[3]
[1]
[2]
[1]
[3]
[4]
F-2-177
22) Detach the feed guide 1 [1].
- 2 screws [2]
[2]
F-2-178
23) Detach the feed roller 1 [1].
- Front side
- 1 screw [2]
- 1 bushing (w/leaf spring) [3]
- 1 E-ring [4]
- 1 bearing [5]
-Rear side
- 1 belt [6]
- 1 E-ring [7]
- 1 pulley [8]
- 1 dowel pin [9]
- 1 bearing [10]
[1]
[5]
[4]
[3]
[2]
F-2-179
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
2.1.6.3 Registration Feed Unit (9 million prints)
imagePRESS C6010 / imagePRE SS C7010VP / imagePRE SS C6010VP /
imagePRESS C7010VP FS / image PRESS C7010V P PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Registration roller (FC5-9624)
2. Replacement procedure
1) Open the front right cover [1] and the front left cover [2] of the main sta-
tion.
[3]
[1]
[2]
[6]
[10]
[9]
[8]
[7]
0026-4809
Advertisement
Table of Contents
