Table of Contents
Advertisement
Chapter 2
14) Remove the Harness Guide [1].
- 1 Screw [2]
- 2 Protrusions [3]
F-2-40
15) Remove the Drum Patch Sensor Shutter Solenoid unit [1] in the direction
of the arrow.
- 2 Screw [2]
F-2-41
CAUTION:
Points to Note when Installing the Drum Patch Sensor Shutter Solenoid Unit
1) Put the wire [1] around the Pulley [2].
2) After temporarily securing the Solenoid Unit [1] with the 2 screws, check
the direction of the end of the wire [2] and fit it to the hook [3] with
tweezers.
2-10
3) Route the wire [1] along the [A] face of the guide [2].
4) Hold the Solenoid Unit [1] so that it completely pulls the wire [2] and
there is no gap at [A].
CAUTION:
Be sure to push the edge of the Solenoid Pin [3], but not the round terminal
[4] of the wire.
Advertisement
Table of Contents
