Hopper / Waste Toner Collection Unit; Sub Hopper Unit (9 Million Prints); Hopper Unit (9 Million Prints) - Canon iPR C7010VP Series Installation Manual

Chapter 2
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Leading edge registration patch sensor (FM4-2564)
2. Before the replacement
1) Remove the Leading Edge Registration Patch Sensor Cleaning Shutter.
Refer to "Chapter 7 Removing the Leading Edge Registration Patch Sen-
sor Cleaning Shutter" in the Service Manual.
3. Replacement procedure
1) Remove the Leading Edge Registration Patch Sen sor [1 ] f rom the IT B
frame.
- 3 Wire Saddles [2]
- 2 screws [3]
F-2-49
2) Remove the leading edge registration patch sensor [1].
- 2 connectors [2]
F-2-50
CAUTION: Point to Note When Attaching
Do not touch the mirror surface [1] of the registration patch sensor. Be sure
to attach the unit by fitting the mirror surface [1] of the registration patch
sensor into the hole [2] of the ITB frame.
2-14

2.1.3 Hopper / Waste Toner Collection Unit

2.1.3.1 Sub Hopper Unit (9 million prints)

imagePRESS C6010 / imagePRE SS C7010VP / imagePRE SS C6010VP /
imagePRESS C7010VP FS / image PRESS C7010V P PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Sub hopper (FM2-2097)
2. Before the replacement
1) Remove the Developing Assembly (Y, M, C, and K). Refer to "Chapter 7
Removing the Developing Assembly" in the Service Manual.
3. Replacement procedure
1) Remove the Sub Hopper (Y, M, C, and K) [1].
- 1 Connector [2]
- 4 Screws [3]
[1] [3]

2.1.3.2 Hopper Unit (9 million prints)

imagePRESS C6010 / imagePRE SS C7010VP / imagePRE SS C6010VP /
imagePRESS C7010VP FS / image PRESS C7010V P PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Hopper unit (Y:FM4-7152,M:FM4-7153,C:FM4-7154,Bk:FM4-7155)
NOTE:
Here shows the procedure of Bk hopper unit as an example of removing a
hopper unit.
2. Before the replacement
1) Open the toner replacement outer cover [1] while the power is turned ON.
[3]
[2]
F-2-51
0026-4484
0026-4485