Left Pull-Out Roller Unit (9 Million Prints) - Canon iPR C7010VP Series Installation Manual

CAUTION: Point to Note When Attaching
Be sure to insert the positioning shaft [1] of the left deck path merger unit
into the attachment hole [2] when attaching the unit.

2.1.7.6 Left Pull-Out Roller Unit (9 million prints)

imagePRESS C6010 / imagePRES S C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Secondary pull-out roller (FC8-1659)
2. Before the replacement
1) Remove the Left Deck Path Merging Unit. Refer to "Chapter 8 Removing
the Vertical Path Unit" in the Service Manual.
3. Replacement procedure
1) Remove the left pull-out roller unit [1].
- 1 grip [2]
- 1 bushing [3]
- 5 screws [4]
[3]
[2]
[4] [1]
F-2-264
2) Remove the following parts.
- 1 E-rings [1]
- 1 flange [2]
- 1 gears [3]
- 1 dowel pins [4]
[2]
[1]
[4]
[4]
[2]
[1]
3) Remove the secondary pull-out roller [1].
0026-4851
- 3 E-rings [2]
- 2 gears [3]
- 1 dowel pins [4]
- 2 bearings [5]
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
CAUTION:
Be sure to fit the [A] joint first when attaching the left pull-out roller unit [1].
[4]
[3]
F-2-265
[2]
[3]
[4]
[2]
[5]
[1]
[5]
[2]
[3]
F-2-266
Chapter 2
2-59