Table of Contents
Advertisement
Chapter 2
[A]
[1]
F-2-165
14) Remove the following parts.
- Harness (1 wire saddle [1])
- 2 connectors [2]
[2]
F-2-166
15) Hold the lever (B-E2) and open the feed unit (upper) [1].
[1]
F-2-167
2-40
[B]
[1]
16) Hold the lever (B-E2). While supporting to prevent the feed unit (upper)
from closing, remove 1 each of the front and rear fixing screws [1] and
gas dampers [2] (only for the upper side).
F-2-168
17) Remove the following parts.
- 1 reuse band [1]
- 1 connector [2]
- Harness (1 edge saddle [3])
[3]
F-2-169
18) Detach the fixing plate [1].
- 1 screw [2]
[2]
F-2-170
19) Detach the shaft support (rear) [1].
- 3 screws [2]
- 1 claw [3]
[2]
[1]
[2]
[1]
[1]
Advertisement
Table of Contents
