Table of Contents
Advertisement
CAUTION: Point to Note When Attaching the Process Unit Cover (2/2)
After lifting the 3 levers [2] of the process unit cover [1], be sure t o shift the
lever (small) [3] while pushing the [A] area to the back. If trying to turn the
lever (small) [3] while the cover [1] is off from the machine, the pin [4]
cannot be set properly and it causes an error.
[1]
[4]
5) Remove the screw [1].
[1]
6) Open the toner replacement outer cover [1] to remove the screw [2].
[2]
7) Remove the main station upper front cover [1] while lifting its left side up.
- 5 claws [2]
[2]
[A]
[3]
F-2-73
[1]
F-2-74
F-2-75
8) Remove the toner supply front cover [1].
- 2 screws [2]
F-2-76
9) Remove the toner supply right cover [1].
- 2 rubber covers [2]
- 2 screws [3]
[1]
F-2-77
10) Move the toner supply assembly [1] in the direction of the arrow.
- 6 connectors [2]
- 3 screws [3]
Chapter 2
[2]
[1]
[3]
[2]
[3]
[2]
2-19
Advertisement
Table of Contents
