Waste Toner Buffer Unit (9 Million Prints) - Canon iPR C7010VP Series Installation Manual

Table of Contents

Advertisement

Chapter 2
F-2-94
27) Remove the 4 feed drive assemblies [1].
- 3 screws [2] each
[2]
[2]
F-2-95
NOTE:
The color (Y/M/C/Bk) is engraved on the plate of the feed drive assembly.
(The image : for yellow.)
CAUTION: Point to Note When Attaching
Check first that the bearing [1] is fitted into the hole, and then tighten the
screw. (The image : for yellow.)
2-24
[1]
[2]
[1]
[2]
[2]
[1]
28) Move down the 2 toner replacement outer cove r hinges [1] and detach
the feed drive support plate [2].
- 6 screws (binding) [3]
- 5 screws (TP) [4]
[4]
[3]
[4]
[2]
[3]
[1]
[3]
29) Remove the feed pipe unit [1].
- 6 screws [2]
[2]
[2]

2.1.3.4 Waste Toner Buffer Unit (9 million prints)

imagePRESS C6010 / imagePRE SS C7010VP / imagePRE SS C6010VP /
imagePRESS C7010VP FS / image PRESS C7010V P PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Waste toner buffer (FM2-2053)
2. Before the replacement
1) Execute the following in Service Mode to discharge the waste toner (du-
ration:approximately 5 min.)
COPIER > FUNCTION > MISC-P > WTNR-ALL
CAUTION: Points to note when exhausting the waste toner
When exhausting the waste toner, be sure to place the waste toner container
in the waste toner storage.
2) Pull out the process unit 100 mm or more.
(To disengage the process unit from the developing waste toner connect-
ing pipe and the drum waste toner connecting pipe.)
3) Pull out the intermediate transfer unit 100 mm or more.
(To disen gage th e ton er ex haust pipe of the ITB cleaner unit from the
waste toner buffer unit.)
4) Pull out the feed assembly 100 mm or more.
(To disengage the to ner exhaust pipe of the secondar y tr ansfer clea ner
unit from the waste buffer unit.)
5) Disconnect the Power Unit Station from the Main Station. Refer to "Chap-
ter 10 Disconnecting the External/Auxiliary Control System Power Unit
Station" in the Service Manual.
6) Detach the sub station rear cover 3 [1] & 4 [2].
- 3 screws [3] (Loosen them)
- 10 screws [4]
[3]
[4]
[3]
[4]
[1]
[3]
F-2-96
[1]
[2]
F-2-97
0026-4531

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ipr c7010vps series

Table of Contents