Table of Contents
Advertisement
CAUTION: Point to Note When Storing the Process Unit
When storing the process unit [1], be sure to hold the harness [2] with its
face up so that it will not be caught in the process unit.
21) Pull each color's process unit until it comes to the position indicated in
the figure below.
[1]
22) Thoroughly cover the top surface of all process units with paper [1].
MEMO: The reason why placing paper over the unit
- To prevent parts lost due to dropping of small parts
- To prevent soil by toner
- To block light to the drum
23) Remove the Main Station Left Transverse Duct [1].
- 3 Screws [2]
[2]
[1]
F-2-89
[1]
F-2-90
F-2-91
24) Lift the Toner Replacement Outer Cover Hinge [1] and remove the Main
Station Front Upper Cover [2].
- 7 Screws [3]
F-2-92
25) Remove the har ness guide (right) [1] and the ha rness guide (left) [2].
(With the bunch line connected)
- 3 screws [3] each
[2]
[3]
F-2-93
26) Remove the 4 gears [1].
- 4 E-rings [2]
CAUTION:
Be careful not to loose the E-ring because it's small
Chapter 2
[1]
[3]
2-23
Advertisement
Table of Contents
