Table of Contents
Advertisement
- 1 screw [5]
- 1 bushing (w/leaf spring) [6]
- 1 E-ring [7]
- 1 bearing [8]
- 1 belt [9]
[9]
[4]
[3]
[2]
[5]
F-2-237
10) Remove the following parts from the duplexing feed roller 1-2 [1].
- Front side
- 1 E-ring [2]
- 1 bearing [3]
- Rear side
- 1 E-ring [4]
- 1 pulley [5]
- 2 dowel pins [6]
[4]
[5]
[6]
F-2-238
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
When detaching the duplexing feed roller 1-1
9) Move the duplexing feed roller 1-1 [1] in the direction of the arrow and
detach it.
- 1 screw [2]
- 1 bushing (w/leaf spring) [3]
- 1 E-ring [4]
- 1 bearing [5]
- 1 belt [6]
[1]
[8]
[7]
[6]
[3]
[2]
[1]
[4]
[3]
[2]
[6]
F-2-239
10) Remove the following parts from the duplexing feed roller 1-1 [1].
- Front side
- 1 E-ring [2]
- 1 bearing [3]
- Rear side
- 1 E-ring [4]
- 1 pulley [5]
- 2 dowel pins [6]
[4]
[5]
[6]
F-2-240
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
2.1.7.3 Main Station Duplexing Feed Unit 3 (9 million
prints)
imagePRESS C6010 / im agePRESS C7010VP / imagePRESS C60 10VP /
imagePRESS C7010VP FS / image PRESS C7010V P PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Duplexing feed roller 1-1 (FC9-9478)
- Duplexing feed roller 1-2 (FC9-9477)
2. the replacement
1) Remove the Main Station Duplex Feed Unit 3. R efer to "Chapter 8 Re-
moving the Main Station Duplex Feed Unit 3" in the Service Manual.
3. Replacement procedure
3-1. Removing the duplexing feed roller 1-1
Chapter 2
[5]
[1]
[3]
[2]
[1]
2-53
0026-4719
Advertisement
Table of Contents
