Table of Contents
Advertisement
[1]
F-2-247
8) Turn over the Main Station Duplex Feed Unit 3, a nd remove the Handle
Shaft [1].
- 2 screws [2]
- 1 link plate [3]
- 2 bushings [4]
[1]
[4]
[2]
F-2-248
9) Detach the lower guide plate [1] by moving it in the direction of the arrow.
- 1 screw [2]
[1]
F-2-249
[4]
[3]
[2]
[2]
When Removing the Duplexing Roller 1-2
10) Remove the duplexing feed roller 1-2 [1] by moving it in the direction of
the arrow.
- 1 E-ring [2]
- 1 pulley [3]
- 1 dowel pin [4]
- 1 screw [5]
- 1 bushing (w/leaf spring) [6]
- 1 E-ring [7]
- 1 bearing [8]
- 1 belt [9]
[9]
[4]
[3]
[2]
[5]
F-2-250
11) Remove the following parts from the duplexing feed roller 1-2 [1].
- Front side
- 1 E-ring [2]
- 1 bearing [3]
- Rear side
- 1 E-ring [4]
- 1 pulley [5]
- 2 dowel pins [6]
[4]
[5]
[6]
F-2-251
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
Chapter 2
[1]
[8]
[7]
[6]
[3]
[2]
[1]
2-55
Advertisement
Table of Contents
