Table of Contents
Advertisement
[1]
[3]
[2]
F-2-171
20) Hold the lever (B-E2) [1]. While opening the feed unit (upper) [2], de-
tach it in the direction of the arrow.
CAUTION:
Be careful not to lose the 2 bushings [1] that are not fixed to the shaft.
F-2-172
[2]
[1]
[1]
[2]
When detaching the pre-registration feed roller 3
21) Detach the pre-registration feed roller 3 [1].
- Front side
- 1 screw [2]
- 1 bushing (w/leaf spring) [3]
- 1 E-ring [4]
- 1 bearing [5]
- Rear side
- 1 belt [6]
- 1 E-ring [7]
- 1 pulley [8]
- 1 dowel pin [9]
- 1 bearing [10]
[6]
[10]
[9]
[8]
[7]
F-2-173
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
When detaching the pre-registration feed roller 1/2
21) Remove the following parts.
- 1 connector [1]
- Harness (1 edge saddle [2])
[2]
F-2-174
22) Detach the feed guide 2 [1].
- 4 screws [2]
Chapter 2
[1]
[5]
[4]
[3]
[2]
[1]
2-41
Advertisement
Table of Contents
