Table of Contents
Advertisement
Chapter 2
2) Remove the duplexing feed roller 4-1 [1].
- Front side
- 2 E-rings [2]
- 2 pulleys [3]
- 1 belt [4]
- 2 dowel pins [5]
- 1 E-ring [6]
- 1 bearing [7]
- Rear side
- 1 belt [8]
- 1 E-ring [9]
- 1 pulley [10]
- 1 dowel pin [11]
- 1 screw [12]
- 1 bushing (w/leaf spring) [13]
- 1 E-ring [14]
- 1 bearing [15]
[8]
[11]
[10]
[9]
[14]
[13]
[12]
F-2-283
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
3-2. Removing the duplexing feed roller 4-2
1) Detach the belt cover [1].
- 2 screws [2]
[2]
F-2-284
2) Remove the shaft pin [1].
- 1 screw [2]
- 1 bushing [3]
2-64
[5]
[3]
[2]
[4]
[1]
[15]
[7]
[6]
[5]
[3]
[2]
[1]
[2]
[1]
F-2-285
3) Remove the shaft pin [1].
- 1 screw [2]
- 1 bushing [3]
[3]
F-2-286
4) Free the harness from the 2 edge saddles [1], and disconnect the 2 connec-
tors [2].
[2]
[1]
F-2-287
5) Detach the wire support [1].
- 2 screws [2]
F-2-288
[3]
[2]
[1]
[2]
[1]
[1]
[2]
Advertisement
Table of Contents
