Table of Contents
Advertisement
4) Remove the bearing [1] on the front side, and then remove the buffer path
roller 2 [2].
- 1 screw [3]
- 1 grounding plate [4]
- 1 sintered bushing [5]
- 1 E ring [6]
[1]
[6]
[5]
[2]
F-2-435
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
CAUTION: Point to note when attaching
- For better workability, open the buffer path guide [1].
- Do not touch the 2 rubber rollers [2] with bare hand.
- Attach the roller with the slot [3] facing to the rear side.
[3]
[2]
2.2.15 Multi Path Unit
2.2.15.1 Multi Path Unit
imagePRESS C6010 / imagePRES S C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
[4]
[3]
[1]
0026-5021
[1]
[2]
F-2-436
T-2-16
No.
Name of part
[1]
Multi path roller 1
[2]
Multi path roller 2
1) Remove the multi path unit.
Please refer to "R emoving Multi Pa th Unit" in "POD Deck A1 Servi ce
Manual."
2) Open the multi path upper guide [1] to remove the hook support [2].
- 3 screws [3]
[3]
[1]
[2]
[3]
F-2-437
3) Turn the multi path unit upside down to remove the base plate [1].
- 2 screws [2]
[2]
F-2-438
4) Remove the sensor mount [1].
- 1 screw [2]
[1]
F-2-439
5) Remove the motor mount [1] and the timing belt [2].
- 2 screws [3]
Chapter 2
Qty.
1
1
[1]
[2]
[2]
2-107
Advertisement
Table of Contents
