Table of Contents
Advertisement
17) Detach the main station rear cover 1 [1].
- 8 screws
18) Detach the main station rear cover 3 [2].
- 4 screws
[2]
19) Detach the rear upper reinforcing plate [1].
- 23 screws [2]
[1]
[2]
[2]
[2]
[2]
20) Remove the 4 flywheels [1].
- 8 screws (W sems) [2]
[2]
[2]
[1]
[1]
F-2-19
[2]
[2]
[2]
F-2-20
[2]
[2]
[1]
F-2-21
CAUTION: Point to Note When Handling the Drum Gear
Never make a scar on the drum gear [1] in the subsequent steps. Scars on
the drum gear [1] may result in the fault in output image.
21) Remove the 2 harness guides [1].
- 4 connectors [2]
- 14 wire saddles of the harness guide [1]
- 4 screws [3]
22) Remove the 2 harness guides [4].
- 10 wire saddles of the harness guide [4]
- 3 screws [5]
[5]
[4]
[3]
[1]
[2]
F-2-22
23) Detach the drum drive PCB unit [1]. (1 each for each color)
- 1 wire saddle [2]
- 5 connectors [3]
- 2 screws [4]
- 1 harness [5] (only at the front side of [1])
[4]
[3]
[5]
[1]
F-2-23
24) Remove the developing waste toner joint pipe [1]. (1 each for each color)
- 4 screws [2]
Chapter 2
[1]
[5]
[3]
[1]
[2]
[3]
[4]
2-5
Advertisement
Table of Contents
