Manual Feed Registration Roller - Canon DADF-R1 Service Manual

5) Move the side guides (front) [1]/(rear) [2] to the
inside; then, remove the 2 screws [3], and detach
it.
[1]
[3]
F-4-79
After mounting it, be sure to adjust the horizontal
registration.
4.4.10 Manual Feed Registration
Roller
4.4.10.1 Preparation for Removing the
Manual Feed Registration
1) Remove the front cover.
2) Remove the main cover.
4.4.10.2 Removing the Manual Feed
Registration Roller
1) Remove the 3 screws [1], and disconnect the
connector [2]; then, remove the solenoid unit [3]
from the delivery assembly front side plate.
[1]
[2]
F-4-80
[3]
[2]
0013-3578
0013-3579
[1]
[3]
2) Remove the 2 screws [1], and detach the manual
feed registration sensor PCB assembly [2].
[1]
F-4-81
3) Remove the grip ring [2] and the bearing [3] from
the manual feed registration roller [1]. (delivery
assembly front side plate)
[3] [1]
F-4-82
4) Remove the grip ring [2] of the manual feed
registration roller [1].
5) Remove the E-ring [4] of the feeding belt roller
shaft [3].
6) Remove the gear [5] and the parallel pin [6].
Chapter 4
[2]
[2]
4-19