Table of Contents
Advertisement
Chapter 2
[1]
6) Move the equipment [1] in the direction of the arrow [A] and take out the
2 slope plates [2] stored at the center of the palette in the direction of the
arrow [B].
7) Remove the 2 pins [1] and 2 blocks [2] attached to the backside of the
slope plates with tape.
[1]
8) Turn the slope plates over. Fit the palettes to the pin holes on the slope
plates and insert the 2 pins [2].
Place the 2 timbers [2] under the 2 reinforcement parts [3] of the slope
plate.
2-4
[2]
F-2-6
[1]
[A]
[2]
[B]
F-2-7
[2]
[2]
F-2-8
[1]
[2]
[3]
9) Along the slope, slide the equipment carefully from the palette.
2.3.2 A note on Turning ON/OFF the Power of the Host
Machine
CAUTION:
Proper order to turn ON the power when pickup/delivery accessories
are connected.
Be sure to follow the correct order to turn ON the power otherwise it may
cause an error because the host machine fails to recognize the accessories
including the equipment.
<Power-on procedure >
1)Accessories (the equipment and other accessories)
2)Host machine
MEMO:
There is no power-on order among accessories.
CAUTION:
A note on turning OFF the main power of the host machine.
Be sure to turn off the main power in the following order to protect hard disk
of the host machine.
1) Press the power switch on control panel for 3 sec or more.
2) Follow the instruction on the shutdown sequence screen (the main power
switch will go off automatically).
3) Disconnect the power plug.
2.3.3 Before Installing the Finisher
1) Remove all the tapes affixed to the equipment.
[2]
[3]
F-2-9
F-2-10
0020-5491
0020-5493
Advertisement
Table of Contents
