Removing From The Host Machine; Finisher Assembly - Canon Saddle Finisher-AF2 Service Manual

4.1 Removing from the Host Machine

4.1.1 Finisher Assembly

4.1.1.1 Removing From the Host Machine

CAUTION:
If the power supply of the host machine is OFF, make sure that power plug
is put out of the power outlet.
1) Remove the shunt cable [1].
- 2 screws [2]
[2]
2) Removing the signal cable [1] from the host machine.
[1]
[2]
F-4-1
0020-8226
MEMO:
Make sure that trailing terminal connector is installed in the coaxial
connector.
3) Removing rear small cover [1] as the direction of the arrow.
- 1 screw [2]
- 2 hooks [3]
[1]
[2]
[3]
4) Tilt the hinge [1] of the latch mount (rear) as the direction of the arrow.
- 1 screw [2]
Chapter 4
[1]
F-4-2
F-4-3
4-1