Table of Contents
Advertisement
SW382
SW381
SW383
SW384 SW385
(-)
(+)
9) Place A4 paper [1] on the intermediate process tray (Be sure to push in the
paper to the rear side of the process tray).
Then, press switch SW383 [1] to execute stapling.
10) Check that the stapling position is within the specified range [1] of 5 +/-
2mm using this result. If the stapling position is out of the specification,
go through the procedure again from step 6).
CAUTION:
If the LED indicates anything other than "0" meaning the adjustment failure,
execute the adjustment again.
5.3.2.9 Adjusting Staple Position (2-stapling positions)
Execute this adjustment in the case of displacement of stapling position (2-
stapling positions) or replacing EEPROM on the finisher controller PCB.
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
ENTER
[1]
F-5-63
[1]
F-5-64
[1]
F-5-65
4) Remove the screw [2] to remove the switch cover [1].
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
In the case of A-configuration size:
SW382
SW381
0021-1716
In the case of L-configuration size:
F-5-66
[1]
[2]
F-5-67
[1]
SW383
SW384 SW385
(-)
(+)
ENTER
F-5-68
Chapter 5
[1]
5-15
Advertisement
Table of Contents
