Table of Contents
Advertisement
[1]
[2]
6) Measure height [A] from the floor (where the caster is landing) to the up-
per surface of the bottom plate using a scale, and check that the height is
within 86.3 +/- 0.3mm.
7) Loosen the caster's fixing nut [1] with the spanner (large) [2] in [A] direc-
tion.
[2]
CAUTION:
Insert the spanner [3] thru the opening under the saddle bottom plate [2],
when loosening the caster fixing nut [1] at the front side of the saddle
finisher.
[1]
[2]
F-5-5
[A]
86.3 0.3mm
F-5-6
[1]
[A]
F-5-7
[3]
8) Rotate the adjustment bolt [1] with the spanner (small) [2]. Adjust the
height (that is measured in step 6)) to be within 83.6 +/- 0.3mm.
- To raise the height: rotate in [A] direction
- To lower the height: rotate in [B] direction
(Amount of height change per rotation: approx. 1.75mm)
[A]
[2]
9) Tighten the fixing nut [1] in [B] direction.
[B]
10) Adjust the other 3 casters as well (by repeating the steps above).
11) Connect the finisher with the host machine again and check the height.
Install the covers and other parts removed in the previous steps if the
height difference is within +/- 2mm. If not, repeat the steps above to
readjust the height.
5.3.1.2 Side Registration/Skew Adjustment
In the case of shaky vibration on this equipment (due to large operating level
of the side registration unit) or large skew, follow the steps below to execute
adjustment for side registration/skew.
1. Checking adjustment value
1) Turn ON the power switch of the finisher then the host machine.
2) Open the front cover and put the door switch tool into the door switch [1].
Chapter 5
[1]
[2]
[1]
[B]
F-5-8
[1]
F-5-9
0021-1703
5-3
Advertisement
Table of Contents
