Checking Connection; Making Adjustments; Height Adjustment - Canon Saddle Finisher-AF2 Service Manual

Chapter 2
[1]
8) Connect the power plug of the finisher to the outlet.
9) Turn ON the power in the order of the finisher, then the host machine.

2.3.12 Checking Connection

1) Input Connection Step of Finisher.
- Service mode > COPIER > OPTION > ACCPST-D > ACC1-8
MEMO:
In the case of directly connecting to the host machine, enter "1" and press
"OK".
2) Exit from Service Mode.
3) Execute shutdown sequence, and then turn OFF the power of the host ma-
chine/finisher.
4) Turn ON the power of the finisher then the host machine.
CAUTION:
Be sure to power cycle after specifying the connecting order otherwise the
accessories will not be recognized.

2.4 Making Adjustments

2.4.1 Height Adjustment

Depending on the floor condition of the installation site, the height of the fin-
isher needs to be adjusted. If not properly adjusted, paper can be jammed
more frequently in the finisher pickup assembly. Follow the steps below to
adjust the height if necessary.
1.Checking the height
1) Follow the instruction of shutdown sequence, and then turn OFF the pow-
er of the host machine/finisher.
2) Check the height of the finisher and the host machine. The height differ-
ence between the right top [1] of the finisher and the left top [2] of the host
machine should be within +/-2mm.
[1] [2]
3) If the difference exceeds +/-2mm range, adjust the height.
MEMO:
Adjust the height with 4 casters [1] as shown in the figure.
2-26
F-2-92
F-2-93
[1]

2.Height adjustment

1) Separate the finisher from the host machine.
0020-9384
- Disconnect the power plug from the outlet.
- Disconnect the power cable of the finisher.
- Remove the wire saddle at the rear lower cover of the finisher and
disconnect the ARCNET cable.
- Disconnect the shunt cable.
- Remove the latch plates (the front and the rear)
2) Remove the spanner [1] from the finisher front cover.
- 1 screw [2]
[1]
[2]
0020-5980
3) In the case of the finisher, remove the front caster cover [1].
- 1 screw [2]
4) In the case of the saddle finisher, remove the saddle inner cover (lower)
[1].
- 1 screw [2]
- 1 knob [3]
- 3 screws [4]
[1]
F-2-94
[1]
[2]
F-2-95