Table of Contents
Advertisement
Chapter 4
[4]
6) Remove the punching unit [1].
- 2 screws [2]
7) Remove the horizontal registration sensor unit [1].
- 1 flexible cable [2]
- 2 screws [3]
[3]
[1]
4-46
[3]
[1]
[2]
F-4-207
[1]
[2]
[2]
F-4-208
[2]
[3]
F-4-209
4.5.5 Horizontal Registration Sensor PCB
4.5.5.1 Preparation for Removing the Horizontal
Registration Sensor PCB
1) Separate this machine from the connecting device of the host machine.
(page 4-1)Reference[Removing From the Host Machine]
2) Remove the rear upper cover (right). (page 4-3)Reference[Removing
the Rear Upper Cover (Right)]
3) Remove the rear upper cover (left). (page 4-3)Reference[Removing the
Rear Upper Cover (Left)]
4) Remove the rear cover. (page 4-2)Reference[Removing the Rear Cover]
5) Remove the horizontal registration sensor unit. (page 4-44)Refer-
ence[Removing the Horizontal Registration Sensor Unit]
4.5.5.2 Removing the Horizontal Registration Sensor
PCB
1) Reverse the horizontal registration sensor unit [1].
[1]
2) Remove 2 plates [1].
- 2 screws [2]
[1]
3) Remove 2 moving shaft [1].
- 2 screws [2]
[1]
4) Shift the sensor PCB attached mount [1], and remove the horizontal reg-
istration PCB [2].
- 2 screws [2]
F-4-210
[2]
F-4-211
[1]
[2]
F-4-212
0021-6256
0021-6257
Advertisement
Table of Contents
