Delivery Tray; Preparation For Removing The Tray A/B Unit; Removing The Tray A/B Unit - Canon Saddle Finisher-AF2 Service Manual

Chapter 4
2) Remove the cable [1].
- 4 wire saddles [2]
- 1 reuse band [3]
- 1 connector [4]
- 1 edge saddle [5]
- 2 screws [6]
[2] [3]
[4]
3) Open the front cover.
4) Remove the shaft retainer plate [1].
- 1 screw [2]
5) Open the upper cover unit [1].
6) Lift the upper cover unit [1] a little as the direction of the arrow, and re-
move the dumper shaft [2].
- 1 screw [3]
4-4
[5] [6]
[1]
F-4-11
[2]
[1]
F-4-12
[1]
F-4-13
7) Remove the upper cover unit [1] by sliding it as the direction of the arrow.
CAUTION:
Do not get the cable in the upper cover unit hooked into the hole in the
frame.
[1]

4.2.4 Delivery Tray

4.2.4.1 Preparation for Removing the Tray A/B Unit

1) Remove the rear upper cover (right). (page 4-3)Reference[Removing
the Rear Upper Cover (Right)]
2) Remove the rear upper cover (left). (page 4-3)Reference[Removing the
Rear Upper Cover (Left)]
3) Remove the rear cover. (page 4-2)Reference[Removing the Rear Cover]
4) Remove the inside cover (upper). (page 4-9)Reference[Removing the
Inside Cover (Upper)]

4.2.4.2 Removing the Tray A/B Unit

MEMO:
Remove tray A unit [2] first, before removing the tray B unit [1].
[1]
[2]
F-4-14
F-4-15
0020-7827
0020-8338