Chapter 2
[1]
8) Check the height between the finisher [1] and the High Capacity Stacker.
CAUTION:
Height difference should be within +/-2mm. Execute "Height Adjustment"
if the difference is +/- 2mm or more.
[1]
9) Install the rear small cover.
10) Install the shunt cable [1].
- 2 screws (RS tightening; M4X10) [2]
2-18
[2]
F-2-60
[2]
F-2-61
[2]
[1]
2.3.9 Connecting with the Perfect Binder
CAUTION:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) On the Perfect Binder's upper left side, install the latch plate (front) [1]
(for rear) [2].
- 4 screws (RS tightening; M4X10) [3]
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
For front [1]: F
For rear [2]: R
[2]
F-2-62
0020-9252