Canon Saddle Finisher-AF2 Service Manual page 34

Chapter 2
5) Close the front cover of the finisher.
6) Move the latch mount (rear) [1] in the direction of the arrow and insert it
to the pin to fix it.
- 1 screw [2] (use the screw removed in step 7) "Before Installing the
Finisher")
2-8
[1]
[2]
F-2-22
[1]
7) Check the height between the finisher [1] and the host machine [2].
CAUTION:
Height difference should be within +/-2mm. Execute "Height Adjustment"
if the difference is +/- 2mm or more.
[1] [2]
8) Install the rear small cover.
9) Install the shunt cable [1].
- 2 screws (RS tightening; M4X10) [2]
[2]
F-2-23
F-2-24