Table of Contents
Advertisement
[1]
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front door and put the door switch tool into the door switch [1].
4) Remove the screw [2] to remove the switch cover [1].
[1]
[2]
M101
F-5-190
[1]
F-5-191
F-5-192
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
6) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
7) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW384 once, the LED [3] indicates "+1" and feeding
distance of the paper is increased as shown in the figure below (+
direction).
- Adjustment range: 0 to +59 (2mm-change per unit)
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
[2]
8) Press switch SW385 [1] again to complete this adjustment.
Chapter 5
ENTER
F-5-193
ENTER
[1]
F-5-194
F-5-195
5-41
Advertisement
Table of Contents
