Adjustment In The Case Of Failure In Stacking Performance Of Tray (Upper Curl) - Canon Saddle Finisher-AF2 Service Manual

Chapter 5
MEMO:
In the case of failure as referred to above, make the adjustment in negative
direction to clear the problem.
SW382
SW381
SW383 SW384 SW385
(-) (+)
[1]
8) Press switch SW385 [1] again to complete this adjustment.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5.3.2.21 Adjustment in the Case of Failure in Stacking
Performance of Tray (upper curl)
Execute this adjustment in the case of failure in tray stacking (upper curl) as
shown in the figure below or replacing EEPROM (IC107) on the finisher
controller PCB.
5-32
[3]
ENTER
[2]
F-5-139
[5]
(+)
(-)
[4]
F-5-140
ENTER
[1]
F-5-141
MEMO:
Executing this adjustment enables the finisher to increase feeding speed at
the timing that the paper's trail edge reaches the delivery roller.
As a result, the trail edge of paper does not stay around the delivery outlet
and the tray stackability will improve.
Following describes the detailed adjustment method:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
4) Remove the screw [2] to remove the switch cover [1].
0021-1729
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-142
[1]
F-5-143
[1]
[2]
F-5-144