Table of Contents
Advertisement
Chapter 5
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
[2]
[5]
8) Press switch SW385 [1] to complete adjustment of the feed belt.
"0" indication on the LED means normal completion of the adjustment.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
9) If the LED indication is anything other than "0" meaning the adjustment
failure, execute the adjustment again.
5.3.2.7 Adjusting Staple Position (1-stapling at the rear)
Execute this adjustment in the case of displacement of stapling position (1-
stapling at the rear) or replacing EEPROM on the finisher controller PCB.
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
5-12
[3]
[4]
F-5-46
[2]
ENTER
[1]
F-5-47
4) Remove the screw [2] to remove the switch cover [1].
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
SW382
SW381
0021-1713
6) Press switch SW385 [1] to start adjustment of the 1 stapling position at the
rear.
In the case of A-configuration size:
F-5-48
[1]
[2]
F-5-49
[1]
SW383
SW384 SW385
(-)
(+)
ENTER
F-5-50
[1]
Advertisement
Table of Contents
