Connecting With The High Capacity Stacker - Canon Saddle Finisher-AF2 Service Manual

Chapter 2
[2] [1]

2.3.8 Connecting with the High Capacity Stacker

CAUTION:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) Remove the face cover [1], [2], [3] of the high volume stacker left side.
(the removed plate will not in use anymore).
- 4 screws (RS tightening; M4X10) [3]
[4]
[1]
[4]
[3]
[4]
2) On the High Capacity Stacker's upper left side, install the latch plate
(front) [1] (for rear) [2].
- 4 screws (RS tightening; M4X10) [3]
2-16
[2]
F-2-53
[2]
F-2-54
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
For front [1]: F
For rear [2]: R
R
[2]
[3]
0020-9251
3) Fit the positioning pin [1].
- 2 screws (RS tightening; M4X10) [2]
[1]
[2]
4) While lifting the latch plate (front) [1] up, fit the High Capacity Stacker's
positioning pin [2] into positioning board's hole [3] of the finisher, to con-
nect the finisher with the High Capacity Stacker.
<Front side>
[2]
[1]
[1]
[3]
F-2-55
[1]
F-2-56
F