Connect Water To Machine - Rancilio EGRO 55 Series Technical Manual

2.2 - 2.12 INSTALLATION INSTRUCTIONS: STEP BY STEP GUIDE
2.4 CONNECT WATER LINE TO MACHINE
PLEASE NOTE: You will need a 3/8" NPT to 3/8" BSPT fi tting to connect the incoming water supply to the water connection of the
Egro 55 series machine.
The incoming water supply line, to the machine should be a male 3/8" NPT fi tting. The water connection on the Egro 55 machine
is 3/8" BSPT.
WARNING: A water softener/fi lter for incoming water supply is REQUIRED. Your warranty will be voided if you do not keep the
water to the machine at less than 3 Grains Per Gallon or less.
1. Flush the water softener/fi lter with approximately 3 gallons of fresh water.
2. Connect the softener/fi lter system to the Egro 55 series machine.
© Copyright 2008. Rancilio North America
This section is intentionally left blank.
- Section 2: Page 4 -
EGRO 55 SERIES TECHNICAL MANUAL
E55_TM_S2_InstallV3