Table of Contents
Advertisement
Basics and mounting
Wiring > Wiring System SLIO periphery
Data
Wiring procedure
Deployment of the power
modules
26
U
30V DC
max
I
10A
max
Cross section
0.08 ... 1.5mm
Stripping length 10mm
1
Pin number at the connector
2
Opening for screwdriver
3
Connection hole for wire
1.
Insert a suited screwdriver at an angel into the square opening as shown. Press
and hold the screwdriver in the opposite direction to open the contact spring.
2.
Insert the stripped end of wire into the round opening. You can use wires with a
cross section of 0.08mm
3.
By removing the screwdriver, the wire is securely fixed via the spring contact to the
terminal.
n
The CPU does not provide a power section supply for the periphery modules. By
plugging the power module with the order no. 007-1AB00 the succeeding periphery
modules get a DC 24V power section supply with max. 10A. If the 10A are no longer
sufficient, another power module must be plugged. So you have also the possibility to
define isolated groups.
n
The periphery modules get their electronic power supply from the CPU with max. 3A.
The power module with the order number 007-1AB10 is to be used if the 3A for the
electronic power supply at the backplane bus is no longer sufficient. Additionally you
get a new isolated group for the DC 24V power section supply with max. 4A.
n
By plugging the power module 007-1AB10, modules with a maximum total current of
the power section supply of 2A can be plugged at the succeeding backplane bus.
Afterwards a power module is to be placed again. To secure the power supply, the
power modules may be mixed used.
2
(AWG 28 ... 16)
2
2
up to 1.5mm
HB700 | CPU | PMC921xEx | en | 23-06
iC9200 Series
Advertisement
Table of Contents
