Table of Contents
Advertisement
Deployment
Web-based management - WBM > Security
Create Syslog server des-
tination
102
Security
iC92...
PMC92...
Syslog Configuration
Information
Diagnostics
Configuration
Security
Certificate Authentication
Firewall
SD Card
Syslog Configuration
User Authentication
Administration
1.
To create a Syslog server destination, click at
ð The dialog for configuring a Syslog server destination opens.
2.
Under 'General Options' enter the following parameters:
n
Host Name
–
Host name respectively IP address of the Syslog server to which the log
data is to be sent.
n
Protocol
–
Transmission protocol to the server. TLS is recommended for secure trans-
mission; for this purpose, a trust store must be defined for verification. This
can be done via
You can specify the corresponding Trust Store at 'Trust Store' .
n
Port
–
Port over which the communication with the Syslog server is to take place.
Ensure that the port is enabled in the firewall settings for outgoing requests.
Ä Chap. 4.9.5.2 'Firewall' page 95
Ä Chap. 4.9.5.1 'Certificate Authentication' page 90.
HB700 | CPU | PMC921xEx | en | 23-06
iC9200 Series
at the bottom of the table.
Advertisement
Table of Contents
