Table of Contents
Advertisement
Basics and mounting
System conception > Hardware revision
Bus cover
Coding pins
2.2.3 Hardware revision
14
With each head module, to protect the backplane bus connectors, there is a mounted bus
cover in the scope of delivery. You have to remove the bus cover of the head module
before mounting a System SLIO module. For the protection of the backplane bus con-
nector you always have to mount the bus cover at the last module of your system again.
The bus cover has the order no. 000-0AA00.
Please note that a coding pin cannot be installed on a 16x periphery
module! Here you have to make sure that the associated terminal block is
plugged again when the electronics unit is replaced.
There is the possibility to fix the assignment of electronic and terminal module. Here
coding pins (order number 000-0AC00) from Yaskawa can be used. The coding pin con-
sists of a coding jack and a coding plug. By combining electronic and terminal module
with coding pin, the coding jack remains in the electronic module and the coding plug in
the terminal module. This ensures that after replacing the electronic module just another
electronic module can be plugged with the same encoding.
n
The hardware revision is printed on every module.
n
Since a System SLIO 8x periphery module consists of a terminal and electronic
module, you will find a hardware revision printed on each of them.
n
Authoritative for the hardware revision of a System SLIO module is the hardware revi-
sion of the electronic module. This is always located under the labeling strip of the
corresponding electronic module.
Depending on the module type, there are the following 2 variants e.g. to indicate
n
hardware revision 1:
–
With current labelling there is a
–
With earlier labelling, the 1 is marked with 'X' on a number grid.
1
on the front.
1
1
1
HB700 | CPU | PMC921xEx | en | 23-06
iC9200 Series
X 2
1
3
4
X 2
3
4
Advertisement
Table of Contents
