Replacing A Cf Card - H3C CR16000-F Installation Manual

Figure 9 Removing the air filter from the other models
1
3. Attach the cleaned air filter to the router.
For the installation procedures, see "(Optional) Installing an air filter on the chassis."

Replacing a CF card

CAUTION:
To avoid hardware or file system damage, do not remove a CF card when the router is booting or the
CF card LED is flashing.
The CF card is installed on the MPU of the router.
To replace a CF card:
1. Observe the CF card LED status.
If the LED is on, you cannot remove the CF card. You must use the

user view to unmount the CF card and wait until the CF card LED is off. If you want to
continue to use the CF card, execute the
card again.
For more information about the
management in H3C CR16000-F Routers Fundamentals Command Reference.
If the LED is flashing, data is being read from or written to the CF card. Only after the LED

stops flashing, you can remove the CF card.
If the LED is off, the CF card is unmounted. You can remove the CF card.

2. Use a Phillips screwdriver to loosen the screw at the right side of the CF card protection cover,
and open the CF card protection cover.
Skip this step if the MPU does not have a CF card protection cover.
3. Push the eject button on the CF card slot all the way until the CF card in the slot ejects. Remove
the CF card from the slot, and put the removed CF card on an antistatic bag or into its original
package.
4. Before inserting the CF card, make sure the CF card eject button is pushed to the end and does
not reset automatically. Push the new CF card all the way into the CF card slot until the eject
button resets.
1
2
2
umount
command in user view to mount the CF
mount
and commands, see file system
mount
8
command in
umount